Monomix WS
(DWI 25(1)(a),
WRAS) - modified
Monomix to allow wet spray application. Waterproof and low density.
Flexcrete's Monomix
WS is a low density, high strength, shrinkage compensated mortar,
which can be applied by wet process spraying techniques for the
structural repair, rendering and profiling of vertical, horizontal
and overhead surfaces.
Monomix WS is a single component cementitious mortar, which
incorporates the most advanced cement chemistry, microsilica, fibre
and styrene acrylic copolymer technology. This results in a rapid
hardening, low density, high strength mortar with enhanced polymer
properties. The thixotropic nature of the product enables easy high
build spray application for the structural repair of voids and the
rendering and re-profiling of vertical, horizontal and overhead
surfaces. The product is supplied as a single component system ready
for on-site mixing and use, requiring only the addition of clean
water.
Advantages of Monomix WS
INNOVATIVE:
Incorporates the latest proven cement chemistry, microsilica, fibre
and styrene acrylic copolymer technology.
EASE OF USE: Materials are pre-packaged and only require
mixing with clean water on site to give a mortar, which can be
applied by wet process techniques with a maximum application
thickness in excess of 80mm in vertical, horizontal and overhead
situations.
SHRINKAGE COMPENSATED: Enables high bond strength, superior
to tensile strength of concrete, to be maintained and ensures
monolithic performance of the repair.
LOW PERMEABILITY: Dense matrix provides excellent protection
from the ingress of acid gases, moisture and chlorides.
FIBRE REINFORCED: Improved tensile and impact strength.
Excellent low sag properties.
COMPLIANCE: Fully complies with the Highways Agency Standard
BD 27/86 for the repair of Highway Structures.
SAFE: Non-toxic when cured and is listed as authorised under
Regulations 31 for use in the supply of water for drinking.
COST EFFECTIVE: High performance, polymer modified, fibre
reinforced cementitious mortar requiring no inter-layer priming.
Part bags can be mixed.
OVERCOATING: Easily overcoated with specialist membranes to
provide further protection and aesthetic quality.
For more
detailed product information download:
Monomix WS Technical
Data Sheet
Monomix WS Safety
Data Sheet
Monomix WS Application
Guide |
